Compared with the ordinary wire drawing machine, the inverted wire drawing machine is actually more focused on drawing thicker wires. Before installation, be sure to select the appropriate location, place the inverted wire drawing machine on a stable ground, and install it according to the instructions.
First, according to the anchor holes of the machine base, use suitable expansion screws to fix it on the pre-laid cement foundation to fix it. After that, check whether the equipment can maintain a stable state, and whether all auxiliary equipment is complete. When tightening the equipment, attention should be paid to adjusting the position of the main machine, the center of the reel and the center of rotation of the trolley are in the same position.
At the same time, note that when adjusting the host, the trolley should be able to keep smooth in the process of moving back and forth. In addition, it is also necessary to properly connect the electrical circuits of the equipment according to the requirements of electricity consumption, without leakage or short circuit. After the installation is complete, it is followed by debugging.
Before that, we need to check whether the installation is complete and whether the various bolts are well tightened. After that, inject an appropriate amount of lubricating oil into the reduction box of the inverted wire drawing machine, and at the same time check its center position through the observation hole, which is highly suitable. In addition, care should be taken to ensure that there is no oil leakage in the reducer housing.
Then make it start under no-load state. At this time, you should pay attention to check whether its running state can remain stable, whether there will be large noise, or obvious vibration problems. During the no-load operation, try to manipulate the control buttons to control the start, normal operation, stop and other actions of the whole machine.
The overall operation of the inverted wire drawing machine is relatively simple, so there is basically no noise during the operation, and the control system is simple and reliable, so the entire production process is very safe. , the main thing is that the daily maintenance is more convenient.
Whether the different lubrication points of the inverted wire drawing machine are completely lubricated, whether the pressure of the water circuit and the air circuit is normal, and whether the drop frame on the trolley is complete; after the power supply of the equipment is connected, turn on the AC main motor, and then stand The vertical wire drawing machine can run for a period of time without load, which is convenient for detailed inspection of the equipment; for the main engine in the inverted wire drawing machine, it should be started slowly, and then it can be gradually increased to reach the normal operating speed.
