1. Horizontal ripple
The interface of the abrasive belt of the water mill wire drawing machine is not smooth, and it is necessary to choose an abrasive belt with a good interface for replacement; the bearing of the rubber roller is damaged, and the bearing needs to be replaced; the surface of the rubber wheel is out of tolerance, and the rubber wheel should be repaired or replaced.
2. Surface flash
The abrasive belt of the water mill wire drawing machine is severely worn and cannot achieve the sand cutting effect. The abrasive belt needs to be replaced in time; the abrasive belt rubber wheel is worn or out of round, and the rubber wheel needs to be ground or replaced; the driven feeding wheel jumps or is out of round, and the feeding wheel should be replaced .
3. Surface clutter
The belt rubber wheel jumps, and the rubber wheel must be repaired or replaced; if the driven feed wheel is loose or the bearing clearance is too large, the bearing should be replaced.
4. Not completely ground
The abrasive belt of the water mill wire drawing machine is partially damaged, and the abrasive belt should be replaced; the workpiece itself is bent and deformed, and the wire drawing is carried out after correction; the rubber wheel is bent or out of round, and the rubber wheel should be repaired or replaced.
5. Broken lines
The abrasive belt rubber wheel of the water mill wire drawing machine jumps, and the rubber wheel should be repaired or replaced; the abrasive belt interface is not smooth, and the abrasive belt needs to be replaced; the lifting gap of the worktable is too large, and the slider gap needs to be adjusted.
